Epson TM-T20II Technical Reference Manual page 49

Character code table default
Selectable from 43 pages including user defined page
Initial setting: Page 0 (PC437: USA, Standard Europe)
For the character code table, see
International character default
Selectable from 18 sets
Initial setting: USA
For the character code table, see
Interface selection (only for serial + USB model, and ethernet + USB
model)
The tables below describe the modes you can set for the printer to control the dual interfaces.
Automatic selection:
The interface for UIB (Universal Interface Board) or Built-in USB to which data is transmitted
first is selected.
When using the Ethernet + USB model, however, the built-in USB is not available for Automatic
selection mode. Select "Fixed to built-in USB" to use the USB interface.
The selected interface is enabled until the power is turned off or the printer is reset.
For serial + USB interface models
Interface mode
Automatic selection (initial setting)
Fixed to serial
Fixed to built-in USB
For ethernet + USB interface models
Interface mode
Automatic selection (initial setting)
Fixed to ethernet
Fixed to built-in USB
"Character Code Tables" on page
"International Character Sets" on page
Serial Built-in USB
Available Available
Available Not available
Not available Available
Ethernet Built-in USB
Available Not available
Available Not available
Not available Available
Chapter 2 Setup
96.
140.
49
2