Epson TM-T20II Technical Reference Manual page 79

4
Press the Feed button three times, and then hold down the Feed button
until the printer starts printing the setting instructions.
5
Select the setting item by pressing the Feed button (no longer than 1
second) for the number of times indicated on the print.
Then hold down the Feed button until the printer starts printing the set-
ting condition.
6
Select the setting condition by pressing the Feed button (no longer than
1 second) for the number of times indicated on the print.
Then hold down the Feed button until the printer starts printing the set-
ting result.
When one setting has been completed, the printer stores the setting.
See "Setting Conditions for Software Setting Mode" on page 93
Customize Value Settings
Modes
0 : Exit
1 : Print Current Settings
2 : Print Density
3 : Printing Speed
4 : Serial Interface Settings
5 : Auto Paper Feed&Cut at cover close
6 : Paper Width
8 : Default Character
9 : Embedded Font Replacement
10 : USB Interface Settings
11 : Buzzer Control
12 : Column Emulation
13 : Interface Settings
15 : Logo Emulation
16 : Automatic Paper Reduction
17 : Interface Selection
18 : Power Supply Unit Capacity
Select Modes by executing following
procedure.
step 1. Press the Feed button less
than 1 second as many times
as the selected mode number.
step 2. Press Feed button for 1
second or more.
Chapter 3 Application Development Information
for the selectable items.
3
79