JVC LT-40FH96 Service Manual page 11

3.1.12 REMOVING THE SPEAKER (Fig.2)
• Remove the STAND.
• Remove the REAR COVER.
(1) Remove the 6 screws [A].
(2) Remove the SPEAKER (L /R).
NOTE:
• Since the speaker is attached in a certain direction, attach
the speaker in the same correct direction as it has been
attached.
• When the speaker is decomposed, the performance cannot
be kept.
3.1.13 REMOVING THE LED PWB (Fig.2)
• Remove the STAND.
• Remove the REAR COVER.
(1) Remove the 2 screws [B].
(2) Remove the LED PWB.
3.1.14 REMOVING THE LED LENS (Fig.2)
• Remove the STAND.
• Remove the REAR COVER.
• Remove the LED PWB.
(1) Remove the 2 screws [C].
(2) Remove the LED LENS.
3.1.15 REMOVING THE CARD PWB (Fig.2)
• Remove the STAND.
• Remove the REAR COVER.
(1) Remove the 3 screws [D].
(2) Remove the CARD BASE ASS'Y.
(3) Remove the CARD SHIELD.
(4) Remove the 4 screws [E].
(5) Remove the CARD PWB.
3.1.16 REMOVING THE SUB POWER PWB (Fig.2)
• Remove the STAND.
• Remove the REAR COVER.
(1) Remove the 4 screws [F].
(2) Remove the SUB POWER PWB.
3.1.17 REMOVING THE LCD PANEL UNIT (Fig.2)
• Remove the STAND.
• Remove the REAR COVER.
• Remove the BACK BRACKET.
(1) Remove the 2 screws [G], 2 screws [H], 3 screws [J] and
1 screw [K].
(2) Remove the MAIN BASE.
(3) Remove the 3 screws [L] and 2 screw [M].
(4) Remove the TOP FARAME.
(5) Remove the 2 screws [N] and 2 screw [P].
(6) Remove the BOTTOM FARAME.
(7) Remove the LCD PANEL UNIT from the FRONT PANEL.
(8) Remove the 2 screws [Q].
(9) Remove the CARD PWB BRACKET from the LCD PANEL
UNIT.
NOTE:
• Pay special attention not to break or damage on the FRONT
PANEL.
• The LCD PANEL UNIT is fixed to the FRONT PAMEL (at the
back side)by using double-side adhesive tapes. To remove
the LCD PANEL UNIT, remove the adhesive tape on the
FRONT PANEL slowly.
(No.YA363)1-11