Optional Outside Air Kit Installation - Napoleon 1600C-1 Installation And Operating Instrictions

18
2.9 MOBILE HOME INSTALLATION
DO NOT INSTALL THIS APPLIANCE IN A BEDROOM / SLEEPING ROOM.
DO NOT INSTALL THE APPLIANCE IN ANY WAY THAT MIGHT COMPROMISE THE STRUCTURAL IN-
MODEL 1600C-1 IS APPROVED FOR INSTALLATION IN MOBILE HOMES IN BOTH CANADA AND THE
UNITED STATES.
The appliance must be secured to the fl oor of the mobile home.
2.9.1 OPTIONAL OUTSIDE AIR KIT INSTALLATION AND FLOOR SECURING
If possible connect the air intake at the bottom to the outside with a 4 inch (100mm) diameter fresh air kit
available at your Authorized dealer.
Connecting the appliance's air intake to the outside as
well as securing the appliance to the fl oor, is mandatory in
mobile homes only. Use a fresh air kit and the fl oor secur-
ing brackets.
Avoid cutting away fl oor joists, wall studs, electrical wires
or plumbing. Seal around the outside pipe with insulation to prevent drafts.
If room air starvation occurs because
the fresh air intake is blocked with ice,
leaves, etc., or because the appliance
door was left open, or due to a strong
exhaust fan operating etc., dangerous
fumes and smoke from the operating ap-
pliance could be drawn into the room.
When installing the 1600C-1 in a mobile
home, use the 111KT Outside air kit in
conjunction with the 113KT Outside Air
Adaptor Kit.
Remove the two screws from the bottom
of the appliance and install the two fl oor
securing brackets using the two screws
removed. Install the vent connector by
inserting the stud retainer into the hole in
the bottom of the appliance. Position the
retainer so that the studs come through
the holes indicated. Hold the retainer in
place and align the holes in the vent con-
nector with the studs of the retainer.
Secure the vent connector in place using
the 2 nuts supplied.
Secure the appliance to the fl oor us-
ing the securing brackets and the two
#10x1.5" screws supplied.
W415-0721 / 06.25.09
TEGRITY OF THE MOBILE HOME FLOOR, WALLS, CEILING, OR ROOF.
WARNING
!
HARDWARE INCLUDED:
# QTY.
1 2
2 2
3 1
FLOOR
SECURING
BRACKETS
CONNECTOR
DESCRIPTION
1
#10 X 1.5" screws
3
nuts
stud retainer
STUD
RETAINER
VENT
2