Table of Contents
Advertisement
1-4 Installing on the Printer
Step2: Install the Blower-fan Unit
WARNING
Remove the cover L and R.
Push the part of figure below until it engage with an audible click.
Lift the cover in the direction of
Attach the stays.
The stays for the left and right are different. Attach them in the orientation shown in the figure.
Stay (left)
Hex-
agonal
wrench
20
Chapter 1 Introduction
Perform this task with all power switches left switched off.
Otherwise sudden movement of the machine may cause injury.
, and then pull it out in the direction of
Bolt
.
Stay (right)
The right stay has
the hole shown in
the figure.
Advertisement
Table of Contents
