Sharp 802SH Service Manual page 50

802SH
Through-hole
[Spacer, Speaker Lead Wire]
Frame, BBK Shield
Standard Standard
position: position:
Do not exceed from the IC's outline.
Do not cover the BBK shield frame.
[Spacer, CSP]
Attach along with the
lower resist line of the
factory identification
mark ( ).
Standard position:
Standard position:
Attach the connector
along with the centre
line.
Standard position:
Attach along the resist line.
[Tape, Kapton]
CONFIDENTIAL
Standard position:
The left and right edges
must be between the
through-hole and the round
land (small).
Round land (small)
Standard position:
Align with the lower
gold-plated line
Spacer,
Speaker Lead Wire
SD PWB-C
MAIN PWB-A
IC1000
Spacer, CSP
Standard position:
Align with the BBK
shield frame line.
Display PWB-B (Rear Side)
Tape, Kapton
Standard
position
Holder,
SD PWB
[Spacer, Speaker Holder]
Standard
position
Holder,
SD PWB
[Camera Cushion, Bottom]
Standard
position
Do not place on
the BBK shield
case cover.
Standard position
To the centre of the marking on
the BBK shield case cover.
No protrusion from the marking.
Do not get into
the cutout area.
Standard position
To the centre of
the thin coaxial
(Earth FPC)
[Thin Coaxial (Earth FPC)/FPC Retainer Kapton]
3 – 2
Standard
position Jig
Spacer,
Speaker Holder
Standard
Camera Cushion,
position
Bottom
Main PWB-A
Thin Coaxial (Earth FPC)
Standard position
Do not go beyond
the thin coaxial
(flexible earth)
FPC Retainer Kapton