Table of Contents
Advertisement
TUONO 1000
2.1.8.
INSTRUMENT PANEL OPERATION
CONTROLS
Three-position selector (1) : TRIP1 / TRIP2 / ODO
SET button (2) : press briefly to scroll menu functions, hold
down to confirm selection.
When the ignition key is turned to " ", the following
instrument panel lights come on for two seconds:
•
All warning lights
•
Backlighting
•
The Tuono 1000 logo appears on the display.
The rev counter pointer (3) moves to the maximum rpm value
set and then returns to its initial position.
During the initial check-up, all instruments will briefly show
the current values of the corresponding parameters.
With the ignition key in position " ", standard display readouts
are as follows:
A.
CLOCK
B.
CURRENT SPEED
C. ODOMETER
D. ENGINE TEMPERATURE
TRIP 1 AND 2
TRIP 1 and 2 modes display trip meter readouts 1 and 2.
Trip meter reading is displayed at the side of the
measurement unit indication.
To select TRIP 1 or TRIP 2 mode, set selector (1) to the TRIP
mode you want displayed.
The following indications are displayed in the lower portion
(C) of the display:
•
TRIP METER 1/2
•
RIDING TIME 1/2
•
TOP SPEED 1/2
•
AVERAGE SPEED 1/2
Press the SET button (2) briefly to cycle through the different
indications. Hold down the SET button to reset all readings of
the selected TRIP meter.
PERIODIC MAINTENANCE
2 - 25
Advertisement
Chapters
Table of Contents
