Pride Mobility Legend 3-wheel Owner's Manual page 30

V I I I .
SEATBACK ADJUSTMENT
WARNING! Do not operate your scooter with the seatback in a reclined position.
WARNING! Always keep your back pressed firmly against the seat back while adjusting it.
To adjust your Legend's reclining seat, perform these steps. See figure 10A.
1. While pulling up on the seatback adjustment lever, lean forward or backward to adjust the seatback.
2. Release the seatback adjustment lever once the seat is in a comfortable riding position.
ARMREST ANGLE ADJUSTMENT
The armrests of your scooter can be adjusted upward or downward. See figure 10B.
n By turning the adjustment dial, the armrest will either raise or lower.
NOTE: The armrests also pivot upward to make getting on and off of your scooter easier.
Figure 10A. Seatback Adjustment Lever
SEAT HEIGHT ADJUSTMENT
The seat can be repositioned to different heights. See figure 11.
1. Remove the seat and shroud from your Scooter. See IX.
“Disassembly and Assembly.”
2. Loosen the seat height adjustment bolt-nut and remove it
from the bolt. Remove the bolt and washers.
3. Loosen the seat post bolt.
4. Raise or lower the upper seat post to the desired seat height.
5. While holding the upper seat post at that height, match up
the locating holes in the upper seat post with those of the
lower seat post.
6. With one washer on the seat height adjustment bolt insert it
through the locating holes of both the upper and lower seat
posts. Reinstall the other washer and bolt-nut and tighten.
NOTE: Ensure both washers have been reinstalled before
fully tightening the bolt-nut.
7. Tighten the seat post bolt
8. Reinstall the rear shroud and the seat.
30
C O M F O R T
www.pridemobility.com
A D J U S T M E N T S
Figure 10B. Armrest Angle Adjustment
SEAT HEIGHT
ADJUSTMENT
BOLT—NUT
SEAT POST
BOLT—NUT
Figure 11. Seat Height Adjustment
ADJUSTMENT
DIAL
UPPER SEAT
POST
LOCATING
HOLES
SEAT HEIGHT
ADJUSTMENT
BOLT
SEAT POST
BOLT
LOWER SEAT POST
Legend/Rev D/July03