Kodak i30 / i40 User Manual page 71

68
Cleaning the calibration area
1. Remove dust and debris from this area by using a Staticide wipe or
a small brush. Be careful not to scratch the glass when cleaning.
IMPORTANT: Staticide wipes contain isopropanol which can cause eye
irritation and dry skin. Wash your hands with soap and
water after performing maintenance procedures. Refer to
the MSDS for more information.
2. Wipe the upper and lower calibration area again with an almost-dry
Staticide wipe to remove any streaks.
3. When finished, close the scanner cover.
A-61512 May 2006