Check Receive Errors; Stop Bit Select - Symbol DS 3478 Product Reference Manual

7-12 DS 3478 Product Reference Guide

Check Receive Errors

Select whether or not to check the parity, framing, and overrun of received characters. The parity value of received characters is
verified against the parity parameter selected previously.
*
Check For Received Errors
(Enable)
Do Not Check For Received Errors
(Disable)

Stop Bit Select

The stop bit(s) at the end of each transmitted character marks the end of transmission of one character and prepares the receiving
device for the next character in the serial data stream. The number of stop bits selected (one or two) depends on the number the
receiving terminal is programmed to accommodate. Set the number of stop bits to match host device requirements.
*
1 Stop Bit
2 Stop Bits