Table of Contents
Advertisement
This fireplace has a three-prong, grounded electrical plug. This plug helps protect
you against electrical shock. Only connect plug to a properly grounded, three-prong
receptacle. Do not cut or remove the grounded prong from this plug.
IMPORTANT: Always check local building codes. The installation must comply with local regulations
as well as the national electric codes.
110/115
V.A.C.
If any of the original wire as supplied with the fireplace must be replaced, contact dealer for proper replacement wiring
harness. (see parts list for part number). 120 volts, 60Hz, 1 amps.
Electrical power cord (plug) can be routed to exit the DIS33 on either the left side or the right side. Remove cord protector
from side of unit, route power cord through hole opposite side. Reinstall cord protector.
26D3311
Never attempt to service heater while
it is plugged in, operating, or hot.
Burns and/or electrical shock could
result.
Fan Switch
OFF
Black
ON
White
Green
Figure 26 - DIS Wiring Diagram
ELECTRICAL WIRING (FAN)
Thermostat
Control
Blower
Motor
Black
21
Hide quick links:
Advertisement
Table of Contents
