Table of Contents
Advertisement
VFI33 Vent Free Gas Fireplace System
This fireplace has a three-prong, grounded
electrical plug. This plug helps protect you
against electrical shock. Only connect plug to
a properly grounded, three-prong receptacle.
Do not cut or remove the grounded prong
from this plug.
IMPORTANT: Always check local building codes. The
installation must comply with local regulations as well as
the national electric codes.
If any of the original wire as supplied with the fireplace must
be replaced, contact dealer for proper replacement wiring
harness. (Refer to parts list for correct part number). 120
volts, 60Hz, 1 amp.
110/115
V.A.C.
Figure 24. VFI Wiring Diagram
WARNING!
Fan Switch
OFF
Black
ON
White
Green
FP2783
DIS wiring
Monessen • VFI33 Owner Manual • 20307670 • Rev B • 09/16
ELECTRICAL WIRING – FAN
Never attempt to service heater while it is
plugged in, operating, or hot. Burns and/or
electrical shock could result.
Electrical power cord (plug) can be routed to exit the
VFI33 on either the left side or the right side. Remove cord
protector from side of unit, route power cord through hole
opposite side. Reinstall cord protector.
Thermostat
Control
WARNING!
Blower
Motor
Black
23
Advertisement
Table of Contents
