Table of Contents
Advertisement
Setting
Lamp control
Lamp control
This function allows you to change brightness of the
screen.
High .......... Brighter than the Normal mode.
Normal ...... Normal brightness
Eco . ........... Lower brightness reduces the lamp
Lamp life control
Select the lamp operation when the total lighting time of a
lamp exceeds the recommended total hours of use.
Mode 1 .............. The lamp can be turned on even after
Mode 2 .............. The lamp can be turned on even after
exceeding the recommended total
hours of use. But the projector turns off
automatically after 3 minutes.
Note:
• Lamp mode cannot be changed for a while after turning
on the projector. Lamp needs some time to stabilize
after the power is turned on. Stored lamp mode will be
active after the lamp is stabilized.
• If Mode 2 has been selected and the projection lamp
exceedes the recommended total hours of use, the
replacement icon will be displayed at the time of power-
on. Then the projector will turn off after 3 minutes.
Lamp replacement icon
• The Lamp replacement icon will not appear when the
Display function is set to Off (p.45), during Freeze
(p.25), or No show (p.26).
Remote control
This projector provides two different remote control codes:
the factory-set initial code (Code 1) and the secondary code
(Code 2). This switching function prevents remote control
interference when operating several projectors or video
equipment at the same time.
When operating the projector in Code 2, both the projector
and the remote control must be switched to Code 2.
To change the code for the projector:
Select either Code 1 or Code 2 in this Setting Menu.
To change the code for the remote control:
Press and hold both the MENU and IMAGE buttons
together for 5 seconds or more. After changing the code,
make sure the remote control operates properly.
Note:
• When different codes are set on the projector and on the remote control, any operation cannot be made. In that case,
switch the code on the remote control to fit the code on the projector.
• If the batteries are removed from the remote control for a long period of time, the remote control code will be reset.
52
Downloaded From projector-manual.com Sanyo Manuals
power consumption and extends the
lamp life.
exceeding the recommended total
hours of use.
Lamp life control
Remote control
Advertisement
Table of Contents
