Resetting The Player; Dvd-Video Regions; Selecting Languages Using The Language Code; List - Pioneer DV-300-K Operating Instructions Manual

Additional information

Resetting the player

Use this procedure to reset all the player's
settings to the factory default.
1 Switch the player into standby.
2 Using the front panel buttons, hold
down the (stop) button and press
STANDBY/ON to switch the player back
on.
All the player's settings are now reset.

DVD-Video regions

All DVD-Video discs carry a region mark on the
case somewhere that indicates which
region(s) of the world the disc is compatible
with. Your DVD player also has a region mark,
which you can find on the rear panel. Discs
from incompatible regions will not play in this
player. In this case the attention sentence
Incompatible disc region number Can't
play disc is displayed on screen. Discs
marked ALL will play in any player.
The diagram below shows the various DVD
regions of the world.
1
2
4
5
1
6 2
3
5
2
4
Selecting languages using the
language code list
Some of the language options (such as 'DVD
Menu Lang.' in the Initial Settings) allow you to
set your preferred language from any of the
136 languages listed in the language code list
on page 41.
1 Select 'Other Language'.
2 Use the (cursor left/right)
buttons to select either a code letter or a
code number.
3 Use the (cursor up/down) buttons
to select a code letter or a code number.
See Language code list on page 41 for a
complete list of languages and codes.

Troubleshooting

Static electricity or other external influences
may cause malfunctioning of this unit. In this
case, unplug the power cord and then plug
back in. This will usually reset the unit for
proper operation. If this does not correct the
problem, please consult your nearest Pioneer
service center.
08
39
En