Kodak EasyShare LS633 User Manual page 93

Problem
Picture is not
clear.
Slide show does
not run on
external video
device.
Camera freezes
up when a card is
inserted or
removed.
Chapter 10
Cause
The lens is dirty.
Subject too close when
taking picture.
Subject or the camera
moved while the
picture was taken.
The subject is too far
away for the flash to be
effective.
Auto focus was not
achieved.
Video Out setting is
incorrect.
External device is set
incorrectly.
Camera detected an
error when the card
was inserted or
removed.
Solution
Clean the lens (page
Move so there is at least 23.6 in.
(60 cm) between camera and
subject, or at least 5.1 in. (13
cm) in Close-up mode (Wide).
Place the camera on a flat,
steady surface or use a tripod
Move so there is no more than
11.2 ft (3.4 m) between the
camera and the subject; 6.5 ft
(2 m) in Telephoto.
To take the best possible
pictures, press the Shutter
button half-way and hold.
When the Ready light glows
green, press the Shutter button
the rest of the way down to
take the picture. (If the amber
light blinks, release the Shutter
button and recompose picture.)
Adjust the camera Video Out
setting (NTSC or PAL,
page 59).
See the external device's user's
guide.
Turn the camera off, then back
on. Make sure the camera is
turned off before inserting or
removing a card.
96).
81