Picture Quality Problems - Kodak EasyShare LS753 User Manual

If...
Slide Show does not
run on an external
video device

Picture quality problems

If...
The picture is too dark
or underexposed
The picture is too light
The picture is not clear
Try one or more of the following
Adjust the camera Video Out setting (NTSC or PAL,
page 20).
Make sure the external device settings are correct
(see the device's user's guide).
Try one or more of the following
Use Fill flash (page
not behind the subject.
Move so that the distance between you and the subject is
within the effective flash range (see
To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows
green, press the Shutter button completely down to
take the picture.
Increase Exposure Compensation
Turn flash off (page
Move so that the distance between you and the subject is
within the effective flash range (see
To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows
green, press the Shutter button completely down to
take the picture.
Decrease Exposure Compensation
and try again.
Check if you are in Beach or Snow scene mode
To automatically set exposure and focus, press the Shutter
button halfway and hold. When the ready light glows
green, gently press the Shutter button completely down
to take the picture.
Clean the lens (page
Make sure camera is not in Close-up mode if you are
further than 39 in. (100 cm) from your subject.
Place the camera on a flat, steady surface or use a tripod.
Troubleshooting
14) or change your position so light is
page
(page
14).
page
(page
49).
14).
16) and try again.
14).
16)
(page 10).
41