Troubleshooting
If
Picture is too light
Picture is not clear
Direct printing (PictBridge) problems
If
Cannot locate desired picture.
The Direct print menu interface
turns off.
Cannot print pictures.
48
Try one or more of the following
■
Reposition camera to reduce the amount of available light.
■
Turn flash off
(page
■
Move so that the distance between you and the subject is within the
effective flash range
■
To automatically set exposure and focus, press the Shutter button
halfway. When the AF/AE indicator turns green, press the Shutter
button completely down to take the picture.
■
Use P mode to adjust the Exposure.
■
To automatically set exposure and focus, press the Shutter button
halfway. When the AF/AE indicator turns green, press the Shutter
button completely down to take the picture.
■
Clean the lens
(page
■
Make sure camera is not in Close-up mode if you are more than
27.6 in. (70 cm) from your subject.
■
Place the camera on a flat, steady surface or use a tripod, especially
in high-zoom settings or in low light.
Try one or more of the following
■
■
Press any button to redisplay the menu.
■
■
9).
(page
9).
58).
Turn on the camera. Make sure the camera is not in
Favorites mode.
Use the Direct print menu to change the image
storage location.
Ensure that there is a connection between camera
and printer
(page
41).
Ensure the printer and camera have power.
www.kodak.com/go/support