Kodak EASYSHARE Z710 User Manual page 39

Setting
White Balance
Choose your lighting condition.
Available only in PASM mode.
Exposure Metering
Evaluate light levels at specific
areas of a scene.
Available only in PASM mode.
Focus Zone
Select a large or concentrated
area of focus.
Available only in PASM mode.
AF Control
Choose an auto-focus setting.
www.kodak.com/go/support
Options
Auto (default)—automatically corrects white balance.
Ideal for general picture taking.
Daylight—for pictures in natural lighting.
Tungsten—corrects the orange cast of household light
bulbs. Ideal for indoor pictures under tungsten or halogen
lighting without flash.
Fluorescent—corrects the green cast of fluorescent
lighting. Ideal for indoor pictures under fluorescent lighting
without flash.
Open Shade—for pictures in the shade in natural lighting.
Multi-pattern (default)—evaluates lighting conditions
throughout the image to give an optimum picture exposure.
Ideal for general picture taking.
Center-weight—evaluates the lighting conditions of the
subject centered in the viewfinder. Ideal for backlit subjects.
Center-spot—similar to Center-weight, except the
metering is concentrated on a smaller area of the subject
centered in the viewfinder. Ideal when you need an exact
exposure of a specific area in the picture.
Multi-zone (default)—evaluates 3 zones to give an even
picture focus. Ideal for general picture taking.
Center-zone—evaluates the small area centered in the
viewfinder. Ideal when precise focus of a specific area in the
picture is needed.
Continuous AF—uses TTL-AF (Through-The-Lens). Because
the camera is always focusing, there is no need to press the
Shutter button halfway down to focus.
Single AF (default)—uses TTL-AF when the Shutter button
is pressed halfway down.
Doing more with your camera
33