Kodak EASYSHARE V1233 User Manual page 58

Troubleshooting
Status
Computer does not
communicate with
the camera
Picture quality problems
Status
Picture is not clear
Picture is too dark
52
Solution
■
Make sure the battery is charged and installed correctly (see
page 1).
■
Turn on the camera.
■
Make sure the USB cable model U-8 is connected to the camera
and the computer. (Use a USB / A/V adapter. See
using an EasyShare dock, check all cable connections. Make sure
the camera is seated on the dock.)
■
Make sure EasyShare software is installed (see
Solution
■
To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■
Clean the lens (see
■
Make sure the camera is not in Macro mode if you are more than
27.6 in. (70 cm) from your subject.
■
Place the camera on a flat, steady surface or use a tripod (especially
in high-zoom settings or in low light).
■
Reposition the camera for more available light.
■
Use Fill flash (see
behind the subject.
■
Move so that the distance between you and the subject is within the
effective flash range. (See camera specifications starting on
page 56.)
■
To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
page 58).
page 9) or change your position so light is not
www.kodak.com/go/support
page 46.) (If
page 45).