Copying Data On The Hdd Or Sd Card To A Pc; Operating Environment - Panasonic VW-PT2 Operating Instructions Manual

¬ Copying data on the
HDD or SD card to a PC
If you connect this unit to a PC using the
USB cable, it can be used as an external
drive on the PC.
≥ The [COPY] button and the [CANCEL]
button cannot be operated while this
unit is connected to a PC. Also, the
power will not turn off even if the
power switch is set to [OFF].
Disconnect the USB cable (P13, 13) and
then operate the unit or turn off its power.
≥ The HDD capacity lamp goes out while
this unit is connected to a PC.
≥ Even if you connect this unit to a PC it
will not be recognized by the PC while
copying data on an SD card to the HDD.
≥ Be sure to place this unit on a level
surface when the HDD SAFETY switch
is set to [ON]. (P10) If the HDD SAFETY
detection switch is activated, the copying
may remain stopped, the data being
copied may be destroyed or an error
may occur on the PC.
Important note
Do not format this unit's HDD on a PC.
You will no longer be able to use the
HDD if you format it on a PC.
If using Windows

∫ Operating environment

Personal computer
IBM PC/AT compatible personal computer
OS
Microsoft Windows Me
Microsoft Windows 2000 Professional
Microsoft Windows XP Home Edition
Microsoft Windows XP Professional
Interface
USB port
Other requirements
Mouse or equivalent pointing device
≥ Use an OS standard driver for operation.
≥ Also, check the operating environment of
any software you are using.
12
VQT1B03
≥ Even if the system requirements
mentioned in these operating
instructions are fulfilled, some personal
computers cannot be used.
≥ This software is not compatible with
Microsoft Windows 3.1, Windows 95,
Windows 98/98SE and Windows NT.
≥ Operation is not guaranteed on an
upgraded OS.
≥ Operation on an OS other than the one
pre-installed is not guaranteed.
≥ When 2 or more USB devices are
connected to a PC, or when devices are
connected through USB hubs or by using
extension cables, proper operation is not
guaranteed.
≥ When connecting the unit to a
"Windows 2000" OS PC with the USB
cable, do not replace the SD card while
the unit and the PC are connected. The
information on the SD card may be
damaged. Disconnect the USB cable
before replacing the SD card.
Refer to "To disconnect the USB cable
safely" on page 13 when disconnecting
the USB cable.
1
Insert the battery or connect this
unit to the AC adaptor.
≥ We recommend connecting the AC
adaptor and inserting the battery to
power the unit for use.
2
Connect this unit to the PC and then
turn on the power on this unit.
AUSB cable (supplied)
≥ The HDD is recognized as
a [Local disk] and the SD card is
recognized as a [Removable disk] on
[My Computer].
≥ Insert the plugs as far as they will go.
The unit and PC will not operate
properly if they are not inserted fully.
≥ Do not use any other USB
connection cables except the
supplied one.
A