Copying Data On An Sd Card To The Hdd - Panasonic VW-PT2 Operating Instructions Manual

≥ If the HDD SAFETY detection switch is
activated while this unit is connected to a
PC, the operation may remain stopped, the
data being copied may be destroyed or an
error may occur on the PC. Be sure to place
this unit on a level surface.
¬ Copying data on an SD
card to the HDD
This is for copying data on an SD card to
the HDD on this unit.
1
Insert the SD card.
2
Set the power switch to [ON].
3
Check that the copy lamp lights green.
≥ The lamp lights green if the
remaining capacity of the HDD is
sufficient to copy all the data on the
SD card to it.
≥ Depending on the operating
conditions, it may take time for the
copy lamp to light after turning on the
power or disconnecting the USB cable.
The HDD is operating so do not move
this unit until the copy lamp lights.
4
Press the [COPY] button.
COPY
≥ Do not remove the SD card while copying.
≥ The copy lamp flashes green at
intervals of about 2 seconds during
copying. Check that the copy lamp
lights green (copying has been
completed normally) and then
remove the SD card.
≥ We recommend copying the data to
the HDD again if you are not able to
verify on the PC that copying has
been completed normally.
∫ To cancel copying halfway
Press and hold the
[CANCEL] button for
2 or more seconds.
CANCEL
≥ If copying is canceled, the file being
copied will be erased. You cannot start
copying again until all the data has
finished being erased. Wait until the
COPY lamp lights green.
∫ About the HDD capacity lamp
The HDD capacity lamp lights to show an
approximation of the HDD capacity.
FULL:Lights green to show there is no free
space on the HDD or the remaining
capacity of the HDD is insufficient to
copy the data on the inserted SD card.
75% :Lights green when the remaining
capacity of the HDD is more than 75%.
50% :Lights green when the remaining
capacity of the HDD is more than
50% but less than 75%.
∫ About the folder structure
Each time data is copied from an SD card to the
HDD, a folder is automatically created and the
data on the SD card is copied to this folder. (A)
Folder structure
ROOT
PANA
070101_1
A
070101_2
070101_a
070101_b
Folder name (
example
The folder name becomes the
070101_1
date that the newest data was
1 2 3 4
recorded on the SD card.
1year 2month 3day 4number
If the HDD SAFETY detection switch is
activated and the copying stops, the data
already copied just before the copying
stops will remain on the HDD. If the
operation starts again, the copying will
start again from the beginning as different
data. A new folder will be created and all
the data will be copied to that folder.
∫ Deleting data on the HDD
Delete unnecessary data on the HDD by
connecting this unit to a PC and then
deleting the data with Explorer (Windows)
or on the desktop (Macintosh). (P13, 13)
The date and time that
the [PANA] folder is
created or updated is
always shown as
"2006 01 01 0:00:00".
)
11
VQT1B03