Charging The Battery - Panasonic VW-PT2 Operating Instructions Manual

¬ Charging the Battery
When this unit is purchased, the battery is
not charged. Charge the battery before
using this unit.
≥ Set the power switch to [OFF] before
charging. If you turn on this unit while
charging, the charging will stop.
≥ Always use genuine Panasonic batteries
(CGA-S303).
≥ If you use other batteries, we cannot
guarantee the quality of this product.
≥ Always use a genuine Panasonic AC
adaptor.
≥ Do not use any other AC adaptors
except the supplied one.
1
Set the power switch to [OFF].
2
Remove the battery cover.
1 While pushing the battery cover A,
2 slide it in the direction of the
arrow.
3
Insert the battery and then close the
battery cover.
1
B
2
1 Place the battery label side B up.
2 Insert the projecting parts C of the
battery in the holes on the unit.
3 Put the battery cover back in its
original place.
8
VQT1B03
2 1 1
2 2
A A
3
C
4
Connect the AC adaptor (supplied)
D to this unit and the AC outlet.
3
4
1 Connect the AC cable to the AC
adaptor.
2 Connect the AC cable to the AC
outlet.
3 Open this unit's terminal cover.
4 Connect the AC adaptor to this
unit's DC input terminal
[DC IN 9.3V].
≥ The status indicator E blinks at
intervals of about 2 seconds and
charging starts. Charging is
completed when the status indicator
goes off.
≥ If the status indicator blinks faster,
refer to page 15.
The is for use with this unit
AC cable
only. Do not use it with other devices
or use the
AC cable
with this unit.
≥ Charging is normally completed after
about 1 hour and 30 minutes when the
temperature is 25 oC (77 oF) and the
humidity is 60%. (The charging time will
differ depending on the operating
conditions.)
≥ The batterie heats up after use or
charging. The unit and the SD card also
heat up during use. This is not a
malfunction.
≥ Be sure to turn off the power [OFF] and
check that the status indicator has gone
out before removing the battery cover
and then removing the battery. Put the
E
D
1
2
for other devices