Mounting The Lens - Panasonic WV-BP330 Operating Instructions Manual

Mounting the Lens

Caution:
Before you mount the lens, loosen the two screws
on the ring, and rotate this ring clockwise until it
stops. If the ring is not at the end, the inner glass
or CCD image sensor may be damaged.
1. Mount the lens by turning it clockwise on the lens
mount of the camera.
2. Connect the lens cable to the auto iris lens con-
nector on the side of the camera.
2
Back-focal
Adjusting Ring
Screws
1
-13-
Caution for Mounting the Lens
The lens mount should be a C-mount or CS-mount (1"-
32UN) and the lens weight should be less than 450g
(0.99 lbs). If the lens is heavier, both the lens and cam-
era should be secured by using the supporter.
The protrusion at the rear of the lens should be as
shown below:
C-mount: Less than 11.5 mm (7/16")
CS-mount: Less than 7.2 mm (1/4")