Lens Mounting - Panasonic WV-SP306 Installation Manual

Lens mounting

Slowly rotate the lens clockwise to mount the lens and connect the lens cable to the ALC lens con-
nector of the camera.
Important:
SP305
• It is impossible to use lenses without the focus adjustment function or zoom lenses.
ALC lens connector
Optional dedicated lens
Product name
ALC lens for 1/3 inch CCD cameras
2x vari-focal (High resolution)
* If a lens for 1/3 inch video camera other than the above is mounted and the camera is used at
resolution of 1 280 x 720 or higher, the camera cannot achieve full performance of high resolu-
tion. It is recommended to use a dedicated high-resolution lens especially when the illuminance
level of the photographic subject is low and the camera is used with the lens iris open.
How to adjust the focus
z
Before adjustment, reset the back focus position by holding down the auto back focus button
for 5 seconds or more when the power is on. (This operation can also be performed on the
setup menu. Refer to the Operating Instructions (PDF).)
x
Adjust the view angle and focus coarsely by adjusting the zoom and focus of the lens to center
a subject in the screen, and then press the auto back focus button on the side of the camera
(☞ page 16) or perform the auto back focus function from the setup menu.
Refer to the Operating Instructions (PDF) for how to perform the auto back focus function from
the setup menu.
SP302
Zoom lock knob
CS-mount lens
(option)
Focus ring
Model number
WV-LZA62/2
SP306
Protruded portion
from mount face:
ø20 mm {25/32"}
or less
Protruded portion from flange face:
4.5 mm {5/32"} or less
1 3
Pin No.
1
2
3
4
2 4
Dump @
Dump !
Drive !
Drive @
17