Desa VH Series Stove"VICTOR HEARTH" Owner's Operation And Installation Manual page 25

oPeration
Continued
After lighting, let pilot flame burn for about
one minute. Turn control knob to ON
position. Adjust flame adjustment knob
anywhere between HI and LO. Slide the
selector switch to the REMOTE position
(see Figure 47). Note: The burner may light
if hand-held remote was on when selector
switch was last turned off. You can now
turn the burner on and off with the hand-
held remote control unit.
IMPORTANT: Do not leave the selector
switch in the REMOTE or ON position
when the pilot is not lit. This will drain
the battery.
Selector Switch in Remote
Position (Optional Remote
Control)
Figure 47 - Setting the Selector Switch,
Control Knob, and Flame Adjustment
Knob for Remote Operation
ON/OFF SERIES (MODEL HRC100)
Hold the control button on the hand-held
remote until burner turns on. Hold the
control button again until burner turns off
(see Figure 48).
TO LOCK press both buttons on hand-held
remote control until light stops flashing.
Hand-held remote control is now locked. If
the fire is on it will be turned off automatically.
In the locked state, the light will not light up
when any button is pressed.
TO UNLOCK press both buttons together
on hand-held remote control until the light
stops flashing. The hand-held remote is now
unlocked.
Indicator
Light
Figure 48 - On/Off Hand-Held Remote
Control Unit (HRC100)
112127-01C
Control Knob
in On Position
LO
IN OUT
Control
Button
www.desatech.com
THERMOSTAT SERIES (MODEL
HRC200)
The hand-held remote can be operated
using either the manual mode (MANU) or
thermostatic mode (AUTO) (see Figure
49). To select Fahrenheit/Centigrade mode
display, carefully press the ˚C/˚F mode but-
ton with the end of a paper clip or similar
blunt object.
Manual Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press the MANU button to turn on the
burner system.
3. Press the POWER and LOCK buttons
together to turn off the burner system.
Auto (Thermostatic) Mode
1. Press the POWER and LOCK buttons
together to turn on the hand-held remote
control.
2. Press AUTO button to select this
mode.
3. Set the desired room temperature by
pressing the TEMP + or - buttons.
4. Press the POWER and LOCK buttons
together to turn off the burner system
Note: Do not leave the hand-held remote
in the AUTO mode close to the stove. The
radiant heat from the stove will turn off the
burner system. Ideally, place the hand-held
remote in the center of the room facing
towards the stove.
Digital Display Shows
Locks
Temperature and Settings
System to
Prevent
Accidental
Ignition
ROOM
TEMP
Turns
LOCK
Burners
On or
MANU
Off
Increases
or Decreases Room
Temperature in
AUTO Mode
Figure 49 - Thermostat Hand-Held
Remote Control Unit (HRC200)
Turns
Hand-Held
Remote On
AUTO
SET
TEMP
or Off and
Allows You
TEMP
to Choose
POWER
the Manual
Setting
AUTO
ºC/ºF
Selects
AUTO
Mode
°C/°F Mode
Button
25