Desa VH Series Stove"VICTOR HEARTH" Owner's Operation And Installation Manual page 21

instaLLation
Continued
INSTALLING OPTIONAL WIRELESS
HAND-HELD REMOTE CONTROL
ACCESSORIES - HRC100 AND
HRC200 SERIES
Installing Remote Receiver
1. Open bottom door on stove body.
2. Disconnect wires from THTP and TH on
control valve that lead to the switch (see
Figure 33, page 19). Discard switch plate,
screws, and nuts.
3. Install battery into receiver battery clip and
connect to terminals (see Figure 36).
4. Place receiver into valve bracket and align
holes (see Figure 37).
5. Use push-in fasteners included with re-
ceiver to secure to bracket.
6. Connect the wires from the receiver to
the valve at TH and THTP (see Figure
33, page 19).
Receiver
9-Volt
Battery
Figure 36 - Installing Battery in Receiver
Figure 37 - Installing Remote Receiver
Installing 9-Volt Battery in Hand-Held
Remote Control Unit
1. Remove battery cover on back of remote
control unit
2. Attach terminal wires to a 9-volt battery
(not included). Place battery into the bat-
tery housing.
3. Replace battery cover onto remote control
unit.
112127-01C
Terminal
Wires
Battery
Clip
www.desatech.com
Battery
Cover
Terminal
Wires
9-Volt
Battery
Figure 38 - Installing Battery in Hand-
Held Remote Control Unit
REMOVING/REPLACING GLASS
DOOR
You must remove glass door to install logs,
lava rock, and ember material. To remove
glass door, you must first remove the front
panel on stove body.
CAUTION: Do not operate
this burner system with a bro-
ken glass door panel or without
the glass door panel securely
in place. For replacement part
information see Replacement
Parts, page 32.
1. If stove front panel is still installed, remove
2 bolts from bottom of stove and one from
the top of stove to remove front panel
(see Figure 39). For the Oxford stove the
middle grate will need to be removed to
remove the top bolt.
Stove Front
Panel
Bolt
Bolt
Figure 39 - Removing Front Panel from
Stove (Oxford™ Model Shown)
Remote
Control Unit
Battery
Housing
Middle Grate
21