Speaker Installation Options; Attaching To A Wall - Panasonic SC-PT860 Operating Instructions Manual

Caution
≥ The main unit and supplied speakers are to be used only as
indicated in this setup. Failure to do so may lead to damage to
the amplifier and/or the speakers, and may result in the risk of
fire. Consult a qualified service person if damage has occurred
or if you experience a sudden change in performance.
≥ Do not attempt to attach these speakers to walls using
methods other than those described in this manual.

Speaker installation options

∫ Attaching to a wall

You can attach all of the speakers (except subwoofer) to a wall.
≥ The wall or pillar on which the speakers are to be attached
should be capable of supporting 10 kg per screw. Consult a
qualified building contractor when attaching the speakers to a
wall. Improper attachment may result in damage to the wall and
speakers.
1 Drive a screw (not included) into the wall.
‰4.0 mm
Wall or pillar
2 Fit the speaker securely onto the screw(s) with the hole(s).
[PT560] Front speaker
[PT860]
Front and surround speakers
Attach to a wall without the base and
the stand
116 mm
384 mm
e.g.
In this position,
the speaker will
DO
likely fall if moved
to the left or right.
NOT
Downloaded From TheatreSystem-Manual.com Manuals
6
6
At least 30 mm
‰7.0 mm to 9.4 mm
4.0 mm to 6.0 mm
Center speaker
190 mm
[PT560] Surround speaker
Move the speaker
so that the screw
is in this position.
DO
Caution
≥ Do not touch the front netted area of the speakers. Hold by the sides.
e.g. Center speaker
DO
NOT
≥ Do not stand on the base.
Be cautious when children
are near.
∫ Fitting speaker stands
[PT560] Center and surround speakers only
[PT860]
Center speaker only
Ensure the stands meet these conditions before purchasing them.
Note the diameter and length of the screws and the distance
between screws as shown in the diagram.
≥ The stands must be able to support over 10 kg.
≥ The stands must be stable even if the speakers are in a high
position.
e.g. Center speaker
Metal screw holes
For attaching to
speaker stands
5.0 mm, pitch 0.8 mm
Plate thickness plus
7.0 mm to 10 mm
∫ Reattaching the speaker cable
Insert the cable from
the bottom.
Leave about
80 mm
DO
e.g. Front speaker
DO
NOT
(not included)
60 mm
Speaker stand
(not included)
Pull out the cable
through the hole.