Bunn Smart Wave Series Installation & Operating Manual page 8

TEA BREWING
1. Begin each brew cycle with a clean empty tea funnel.
2. Insert a BUNN filter into the tea funnel (FIG 8A).
3. Pour fresh tea into the filter and level by gently shaking.
4. Slide the funnel into the funnel rails until it stops.
5. Place an empty server (customer supplied) under the funnel (FIG 8B).
6. Verify that the "ENABLE BREW ON/OFF" switch is on.
7. Momentarily press and release the "BREW B" switch. The display will read "BREWING".
8. After the tea finishes dripping from the funnel tip, carefully remove the brew funnel and discard the tea and
filter. Rinse funnel.
DO NOT REMOVE SERVER UNTIL DILUTION CYCLE IS COMPLETED!
FIG 8A
FIG 8B
Page 8
40410 031314