Bunn Smart Wave Series Installation & Operating Manual page 11

OPERATING CONTROLS - SMART WAVE WITH DISPLAY
B C
D E A
FIG 11
Smart Wave Series
F
(A) ENABLE BREW ON/OFF SWITCH
Pressing the "ENABLE BREW ON/OFF" switch (indicator/display on) enables the brew circuit, and the tank refill
circuit. Pressing the switch again (indicator/display off) stops tank refilling and brewing. Stopping a brew cycle
after it has been started will not stop the flow of water into the server until the funnel is empty.
NOTE 1: – Stopping a brew cycle by pressing the "ENABLE BREW ON/OFF" switch to the "OFF" position, will dis-
able the tank refill circuit. If the level is low enough, tank heating may be disabled as well. Simply pressing the
"ENABLE BREW ON/OFF" switch to the "ON" position will allow the tank to replenish. Allow a few minutes for the
tank to heat back up to it's ready temperature.
NOTE 2: – Hot water will be available at the faucet in a limited amount when the "ENABLE BREW ON/OFF" switch
is in the "OFF" position because the tank will not refill. Refer to NOTE 1 regarding low level.
(B) BREW A SWITCH (-)
Momentarily pressing and releasing the switch starts the selected "A" brew cycle when the "ENABLE BREW ON/
OFF" indicator is on. (Factory set for approx. 64 ounces) (Coffee brewing on combo models)
(C) BREW B SWITCH (+)
Momentarily pressing and releasing the switch starts the selected "B" brew cycle when the "ENABLE BREW ON/
OFF" indicator is on. (Factory set for approx. 64 ounces) (Tea brewing on combo models)
(D) HIDDEN PROGRAM SWITCH (Enter)
(E) STATUS DISPLAY
Indicates tank ready, brew cycle, and drip out cycle.
(F) BATCH SIZE/FLAVOR LABELS
Included
Page 11
40410 013014