Bunn Smart Wave Series Installation & Operating Manual page 13

BREW VOLUME SET-UP:
NOTE: Maximum water on time is 5 minutes.
1. Press the "HIDDEN" switch until display reads C1. This represents the adjust mode "Brew Time" for the "A"
brew switch. The display will then change to (minutes-seconds). Press "BREW A" to decrease time (-) or
"BREW B" to increase time (+).
2. Press and release "HIDDEN" switch until display reads C2. This represents the adjust mode "Brew Meter"
(Pulse Brew) for the "A" brew switch. The display will then change to (1-14). Brewer has 14 preset pulse brew
routines to choose from. Factory default is 1. With 14 being the maximum time. Press "BREW A" to decrease
(-) or "BREW B" to increase (+).
3. Press and release "HIDDEN" switch until display reads C3. This represents the adjust mode "Drip Out Time"
for the "A" brew switch. The display will then change to (minutes-seconds). Press "BREW A" to decrease time
(-) or "BREW B" to increase time (+).
4. Press and release "HIDDEN" switch until display reads T1. This represents the adjust mode "Brew Time" for
the "A" brew switch. The display will then change to (minutes-seconds). Press "BREW A" to decrease time
(-) or "BREW B" to increase time (+).
5. Press and release "HIDDEN" switch until display reads T2. This represents the adjust mode "Brew Meter"
(Pulse Brew) for the "B" brew switch. The display will then change to (1-14). Brewer has 14 preset pulse brew
routines to choose from. Factory default is 1. With 14 being the maximum time. Press "BREW A" to decrease
(-) or "BREW B" to increase (+).
6. Press and release "HIDDEN" switch until display reads T3. This represents the adjust mode "Drip Out Time"
for the "B" brew switch. The display will then change to (minutes-seconds). Press "BREW A" to decrease time
(-) or "BREW B" to increase time (+).
7. Press and release "HIDDEN" switch until display reads T4. This represents the adjust mode "Dilution Time"
for the "B" brew switch. The display will then change to (minutes-seconds). Press "BREW A" to decrease time
(-) or "BREW B" to increase time (+).
8. Press and release "HIDDEN" switch until display reads T5. This represents the adjust mode "Dilution Delay
Time" for the "B" brew switch. The display will then change to (minutes-seconds). Press "BREW A" to decrease
time (-) or "BREW B" to increase time (+). To have a quick dilution, set this time to zero.
NOTE: Advanced programming screens are same as standard Smart Wave.
Adjustment
C1 = Brew switch "A" Brew time
C2 = Brew switch "A" Brew meter
C3 = Brew switch "A" Drip out time
T1 = Brew switch "B" Brew time
T2 = Brew switch "B" Brew meter
T3 = Brew switch "B" Drip out time
T4 = Brew switch "B" Dilution out time
T5 = Brew switch "B" Dilution Delay
PROGRAMMING - SMART WAVE COMBO
Default
2:35
1
0:30
1:15
1
0:30
1:20
3:30
Page 13
Min. Max.
0:26 5:00
1 14
0:05 5:00
0:26 5:00
1 14
0:05 5:00
0:05 5:00
0:00 5:00
Increments
1 second
1
5 seconds
1 second
1
5 seconds
5 seconds
5 seconds
40410 012814