Unpacking The Dispenser; Reshipment; Electrical Requirements; Electrical Servicing - KanPak CDG-211 Operator's Manual

UNPACKING THE DISPENSER

WARNING: Do not attempt to lift the dispenser from the box. Improper lifting may damage the
dispenser.

Inspect the box for any shipping damage.

Remove the protective material from the top and sides of the dispenser.

Remove the corrugated tube from the base.

Remove the dispenser, and other material from the box and inside the dispenser;
Lift the dispenser from the bottom of the equipment.

Remove the plastic protective covering from the stainless steel exterior, if applicable.

Place the dispenser in its final location.

Retain all of the packaging for future reshipment.
CAUTION: Wait 3 hours before plugging in the dispenser to allow the compressor oil to settle.

RESHIPMENT

Packaging for reshipment is done in the reverse order of unpacking. If packaging is not available, it can
be purchased locally, or from KanPak by request. Any damage occurring in transit of the returned goods
caused by improper packaging is not considered a defect covered by warranty.

ELECTRICAL REQUIREMENTS


Be sure the current at the power source receptacle is: 120 VAC, 60 Hz, single phase, 4 Amp.

The dispenser is furnished with a UL-approved 7'power cord. The power cord comes with a 3-
prong (NEMA 5-15) plug, designed to fit a receptacle with provisions for a grounding stud. The
dispenser includes a microprocessor and must be operated on grounded electrical wiring at all
times. Failure to do so will void the Warranty.

To avoid an electrical hazard, if the supplied power cord is damaged, it must be replaced by the
manufacturer, its Authorized Service Agency or by a qualified technician.

ELECTRICAL SERVICING

Electrical servicing must be carried out by a qualified technician. The Warranty will be null and void if
the dispenser is serviced by unqualified personnel.

REFRIGERATION SERVICING

Any servicing of the refrigeration system must be carried out by a qualified technician. The Warranty
will be null and void if the refrigeration system is serviced by unqualified personnel.
CORRECT DISPOSAL OF THIS PRODUCT
This marking indicates that this product should not be disposed with other household
wastes at the end of its working life. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, please recycle it responsibly to
promote the sustainable reuse of material resources.
To return your used device, please contact the manufacturer, the distributor where the product was
purchased, or the local collection system, for details of where and how they can take this product for
environmentally safe recycling.
Page 3