Removing The Moisture Sensor - KitchenAid Pro Line KHEV01RSS Technical Education

REMOVING THE MOISTURE SENSOR

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug dryer or disconnect power.
2. Open the dryer door.
3. Remove the two screws from the moisture
sensor.
Screws
(Viewed From Rear Of Unit With Drum Removed)
Moisture Sensor
4-22
4. Carefully pull the moisture sensor forward,
and slide the two wire connectors out of the
access hole. Disconnect the black and red
wire connectors from the moisture sensor
terminals.
NOTE: The connectors and holes are a
snug fit, so be careful when you remove
the connectors that they do not pull off
their terminals behind the access holes.
The connectors can be difficult to retrieve
if this happens.
Moisture Sensor
Wire Connectors