11. To remove the door sensor:
a) Remove the control panel (see page
4-2 for the procedure).
b) Remove the three T-20 screws from
the door sensor mounting bracket and
remove the bracket and sensor.
Bracket Screws
(1 of 3)
Door Sensor
Bracket
Sensor End Flush
c) Remove the front nut from the door
sensor and remove the sensor from
the bracket. NOTE: When installing the
sensor, keep the end approximately 1/4˝
from the front nut so the tip is flush with
the front panel when it is installed (see
above).
4-4
Front Nut
1/4˝