KitchenAid Pro Line KHEV01RSS Technical Education page 60

10. Lay a covering on the floor in front of the
dryer, large enough to protect the front of
the dryer.
11. Remove the two screws from the door
handle, and remove the handle.
12. Tape the dryer door closed.
13. Tip the dryer onto its front.
14. Remove the four T-20 screws from the duct
support bracket and slide the bracket off
the duct.
Bracket Screws
15. Remove the six T-20 screws from the rear
support panel (see the top right photo).
16. Remove the left screw and loosen the right
screw on the upper cover plate, then rotate
the plate so you can access the screws
that are under it. Tighten the cover screw
to hold it in place.
17. Remove the two 3/16˝ Allen trunnion screws
from the rear of the drum, and remove the
metal washer and nylon spacer.
Trunnion Screws
Duct Support
Bracket
4-20
Washer
Spacer
Cover Plate
Cover Plate & Screws