Table of Contents
Advertisement
P2 card Insertion and Removal
(4) Close the P2 card slot cover.
Return the P2 card slot cover to its
original closed position and press
the section marked PUSH .
When you close the P2 card slot cover
after inserting a P2 card, the [READY]
lamp indicates the recorder status (see
page 48).
(5) Remove the key.
(continued)
Removing a P2 card
(1) Open the P2 card slot cover
(see previous page).
(2) Raise the Eject button.
(3) Push the Eject button so that
the P2 card pops out.
Note:
The [BUSY] lamp blinks for a few
seconds when the P2 card slot
cover is opened. Make sure that
the blinking has stopped before
removing a P2 card.
Notes:
• If a P2 card was removed while it
was being accessed, the files may
be corrupted. Refer to the Operating
Instructions of the Remote Control
Panel to restore corrupted files.
• If a P2 card was removed while it
was being accessed, the P2 card
slot may be disabled. When the
recorder senses a disabled slot, it
may reboot itself automatically.
(4) Close the P2 card slot cover
(see top left of this page).
(5) Remove the key.
17
Advertisement
Table of Contents
