Input Connections; Ac Input; Digital Inputs; Analog Inputs - Klipsch THX ULTRA2 User Manual

SATELLITE
DIGITAL
OUTPUT
S VIDEO
OUTPUT
COMPONENT
ANALOG
OUT SAT
OUTPUT
ANALOG COMPOSITE DIGITAL
OUTPUT VIDEO OUTPUT OUTPUT
S VIDEO
OUTPUT
COMPONENT
VIDEO OUT
DVD PLAYER

INPUT CONNECTIONS

The Stage One allows for analog, digital, and video outputs for seven sources
to be connected to the rear panel inputs. You also have the ability to switch
the Audio and Video signals independently of each other. For easiest opera-
tion, the digital, analog, and video outputs from each source should be
attached to the same source input (lined up vertically) on the rear panel of the
Stage One. If different types of video outputs are available, one of each type
(S-video, Composite, and Component/RGB/HDTV) can be connected to a sin-
gle source input. This ensures that video output will be available regardless of
the input selected on the monitor.

AC INPUT

Using the supplied IEC power cord, plug the Stage One into the wall outlet.

DIGITAL INPUTS

The rear panel of the Stage One provides ten digital inputs (three Toslink, and
seven Coaxial). Any S/PDIF digital output can be connected to any, or all ten
digital inputs. For inputs with both a Toslink and Coaxial digital connection,
Toslink takes precedence. It is possible to connect both a Toslink and a
Coaxial digital signal to a single source input, but only one will be operational
at a time. There is no need to "assign" the digital inputs, as one is provided
for each source connection. For easiest operation, the digital output of the
source should be connected to the same source input (lined up vertically) as
the analog and video outputs of the source.
16
THX SURROUND PREAMPLIFIER
STAGE ONE
CD PLAYER
DIGITAL
OUTPUT
ANALOG
OUTPUT
S VIDEO COMPOSITE ANALOG
ANALOG
OUTPUT INPUT VIDEO INPUT
S VIDEO COMPOSITE
OUTPUT VIDEO OUTPUT
VCR
FM ANTENNA
AM ANTENNA
INPUT COMPOSITE
VISEO INPUT
S VIDEO
INPUT COMPONENT
INPUT
TELEVISION

ANALOG INPUTS

The rear panel of the Stage One provides seven stereo analog line level
inputs. The analog output of any line level source can be connected to any, or
all of the stereo analog inputs. The input gain of the analog inputs should be
adjusted for each analog source that you have connected. For optimum per-
formance, the gain should be adjusted to the highest point before clipping
occurs. (See "Advanced Features.")

VIDEO INPUTS

The rear panel of the Stage One provides 17 Video inputs (seven composite,
seven S-video and three component). The Stage One does not perform any
video conversion. For example, if you connect the S-video output of a DVD
player to the Stage One, that signal will only be available at the S-video out-
puts.

MULTI-CHANNEL ANALOG INPUT

The Stage One provides an 8-Channel Analog Input. This DB-25 connector
can be used to connect the analog outputs from a DVD player with a built-in
decoder. The 8-Channel Analog input is passed directly to the analog pream-
plifier section. Individual channel level adjustment, as well as overall level
adjustment, is available for this input.

ANTENNA INPUT

Spring clips for an AM loop antenna, and a coaxial type terminal for a 75-ohm
FM antenna connection are provided on the rear panel to allow the built-in
AM/FM tuner to be connected to an antenna.
Unbalanced DB-25 Pin Assignments
13
25 14
PIN ASSIGNMENT
1 Left positive
2 Center positive
3 Right positive
4 Subwoofer positive
5 Surround left positive
6 Surround right positive
Surround back left positive
7
Surround back right positive
8
Shield drains
9, 10
No connection
11, 12, 13
14 Left ground
15 Center ground
16 Right ground
17 Subwoofer ground
18 Surround left ground
19 Surround right ground
20 Surround back left ground
21 Surround back right ground
22 Shield drain
23, 24, 25 No connection
1