Asus P9A-I Series User Manual page 75

TJ Target [0]
Sets the PROCHOT# activation temperature offset below TJMAX. The values range from 0˚C
to 63˚C.
TM1 [Enable]
Enables or disables TM1. Configuration options: [Enable] [Disable]
TM1 over TM2 DTYCYC [50.0% clkon]
This option determines how much clock modulation is applied when TM1 over TM2 is
engaged. Configuration options: [100% clkon] [87.5% clkon] [75.0% clkon] [62.5% clkon]
[50.0% clkon] [37.5% clkon] [25.0% clkon] [12.5% clkon]
TM2 Mode [Adaptive Throttling]
Selects LFM Throttling or Adaptive Throttling for TM2 mechanisms. Configuration options:
[LFM Throttling] [Adaptive Throttling]
TM2 Timeout [4]
Sets the time between TM2 steps when configured for adaptive mode.
TM1 Over TM2 Timeout [16]
Sets the duration (in seconds) that TM2 holds off TM1 from being engaged.
TM1 Over TM2 [Enable]
Set this item to [Enable] to allow TM1 to engage after the TM1 Over TM2 Timeout if TM2 has
not cooled the processor. Configuration options: [Enable] [Disable]
Out of Spec Threshold [5]
Reach the temperature over TJMAX before the BIOS must execute a graceful shutdown. The
values range from 0˚C to 63˚C.
Out of Spec Interrupt [Disable]
Enables or disables the generation of a thermal interrupt whenever Out of Spec temperature
threshold is crossed. Configuration options: [Enable] [Disable]
Cold to Hot Hysteresis [0]
Sets the temperature above the temperature when TJ Target PROCHOT# asserts (i.e. HOT).
The values range from 0˚C to 7˚C.
Hot to Cold Hysteresis [2]
Sets the temperature below the temperature when TJ Target PROCHOT# is de-asserted (i.e.
NOT_HOT). The values range from 0˚C to 7˚C.
Low Temp Interrupt [Enable]
Set this item to [Enable] to trigger an interrupt when the temperature goes from HOT to NOT_
HOT. Configuration options: [Enable] [Disable]
High Temp Interrupt [Enable]
Set this item to [Enable] to trigger an interrupt when the temperature goes from NOT_HOT to
HOT. Configuration options: [Enable] [Disable]
ASUS P9A-I Series
4-33