System Configuration
Parallel Port
SATA Operation
Drives
USB Configuration
•
COM1 (Default Setting)
•
COM2
•
COM3
•
COM4
NOTE: The operating system may allocate resources
even if the setting is disabled.
Allows you to configure the parallel port on the docking
station. The options are:
•
Disabled
•
AT (Default Setting)
•
PS2
•
ECP
•
DMA1
•
DMA3
Allows you to configure the internal SATA hard-drive
controller. The options are:
•
Disabled
•
ATA
•
AHCI (Default Setting)
NOTE: SATA is configured to support RAID mode.
Allows you to configure the SATA drives on board. The
options are:
•
SATA-0
•
SATA-1
•
SATA-4
•
SATA-5
Default Setting: All drives are enabled.
Allows you to control the USB controller. The options are:
•
Enable USB Controller (Default Setting)
•
Diasabe USB Mass Storage Dev
139