Performing A Pen Master Reset - HP Digital Pen 250 User Manual

Chapter 4 Troubleshooting
If the pen is still frozen after performing a reset, you can perform a master reset to restore the pen to the
factory settings.

Performing a Pen Master Reset

Caution: Perform a master reset only as a last resort because you will lose all the information in the
pen's memory, including the password.
To perform a master reset, do the following:
Take off the pen cap.
1.
Press the pen tip on a surface while you press the reset button with a paper clip or pencil tip. The
2.
LEDs will flash red.
Remove the paper clip or pencil tip from the reset button, but continue pressing the pen to the
3.
surface. After flashing red for approximately 15 seconds, the LEDs start to cycle through red/
amber/green. The pen can now be lifted from the surface. After a few seconds, the LEDs go back to
their normal state and the pen vibrates to indicate that the reset is complete and it can be used
again.
38 HP Digital Pen 250 User's Guide