Uninstalling The Download Software; Connecting The Digital Pen - HP Digital Pen 250 User Manual

From the drop-down menu, select the installation language and click Select. This selects the
2.
language of the Download Software.
Enter the Service Controller URL supplied by the system administrator, in the format
3.
myserver.mydomain:8080.
Click Next. The License Agreement will be displayed.
4.
You must accept the terms of agreement to install the Download Software. Read the License
5.
Agreement carefully and select I Agree. Click Next.
Choose a folder where you want to install the files.
6.
Once the software installation is complete, select Yes to restart your computer if this is required.
7.
After the Download Software is installed, connect your digital pen to your PC.

Uninstalling the Download Software

To uninstall the pen software, go to Control Panel > Add or Remove Programs, locate the Digital Pen
Software and click Remove.

Connecting the Digital Pen

The HP Digital Pen 250 is connected to your PC by plugging the pen's cradle into a USB port on the PC
and docking the pen.
You can connect more than one pen to a PC either with a single, shared cradle, or by connecting
several cradles. If you want to use a USB hub to connect cradles to the PC, you must use a powered
hub.
Note: The Download Software must be installed before you connect the digital pen to your PC.
To connect the HP Digital Pen 250, use the following procedure:
Make sure your PC is running.
1.
Connect the cradle to the PC using the USB connector.
2.
Remove the pen cap to power on the pen. If the pen battery contains sufficient charge, the memory
3.
and battery status LEDs flash and the pen vibrates once to indicate that it is on.
Note: If the pen does not have sufficient battery charge to power the LEDs dock the pen in the
cradle. When the pen has sufficient charge it powers on automatically, and a "Found new
hardware" message is displayed. This may take up to 20 minutes.
Insert the pen into the cradle. The Microsoft Windows operating system will detect the new
4.
hardware and load the appropriate drivers.
Leave the pen in the cradle until it is fully charged before you use it for the first time. Charging the
5.
battery fully can take up to two hours.
The digital pen icon appears in the task bar. This icon indicates that the pen software is running and
shows whether or not the pen is in the cradle. If the pen is not in the cradle, the icon has a red dot.
HP Digital Pen 250
Chapter 2 Getting Started
User's Guide 13