Elation ELAR PAR 72 UV Manual page 24

<FAIL> DMX Fault Protection
This function dictates how the fixture will operate in the event DMX signal is suddenly
lost while operating in DMX mode. The three fail safe modes are; 1) "OFF" which will
blackout all light output. 2) "HOLD," which will hold the last DMX command, or 3 "AUTO,"
which will put the fixture in sound-active mode.
<DFSE> - Restore Default
This function is used to restore the factory settings of the device. All settings will be set
back to the default values (shaded). Any edited scenes will be lost.
<POHO> - Power on to preserve the MANL settings
This function will preserve all the manual setting that are made in the "MANL" menu
section. If this function is not activated all manual settings will be lost once the fixture is
tuned off.
<VER> Software Version
This function will display the current firmware version.
9.3 "MANL" – Manual Fixture Settings:
This function allows the each of the two DMX channels to be controlled manually. This
will allow the fixture to be preset to a specific color or built-in program without the use of
a DMX console.
9.4 "TIME" – Operating Hours
These functions will detail different time functions associated with the fixture.
<LIFE> (0000~9999 Hours)
This function tracks the running time of the fixture from the point it was last cleared.
Where "XXXX "represents the total number of running hours. This time is none
destructive and will remain in the fixtures memory indefinitely. Use this time to track
rentals or show durations.
©Elation Professional, Los Angeles Ca. 23
ELAR PAR 72 UV
www.ElationLighting.com
™