Step 7 Insert Drain Hose Through Cabinet; Step 8 Slide Dishwasher Partially Into Cabinet; Step 9 Install Trim Pieces; Step 10 Push Dishwasher Into Final Position - GE Built-In Dishwasher Installation Instructions Manual

STEP 7 INSERT DRAIN HOSE
THROUGH CABINET
• Upright the dishwasher and position in front of the
opening. Insert drain hose into cabinet wall hole. If
a power cord is used, guide the end through a
separate hole.
Insulation
Blanket
Figure M
TIP:
Position water line and house wiring on the
floor to avoid interference with base of dishwasher.
STEP 8 SLIDE DISHWASHER
PARTIALLY INTO CABINET
DO NOT PUSH AGAINST FRONT PANEL WITH KNEES.
DAMAGE WILL OCCUR.
• Slide dishwasher into the opening a few inches at a
time.
Do Not Push Against
Front Door Panel With
Knee. Damage to The
Door Panel Will Occur.
• As you proceed, pull the drain hose through the
opening under the sink. Stop pushing when the
dishwasher is a few inches forward of adjacent
cabinetry.
• Make sure drain hose is not kinked under the dish-
washer and there is no interference with the water
line and wiring or any other component.
Installation Instructions
Maximum Drain Hose
Length 10'
Water
Line
Drain
Hose
House
Wiring
Power Cord
(If Used)
Figure N

STEP 9 INSTALL TRIM PIECES

Skip this step if trim is not supplied with the dishwasher.
• Locate trim strips inside dishwasher.
• Press trim onto the tub flange on each side. Start with
the top edge, pressing on as you move towards the
bottom.
• Press the two top trim pieces on each side of the latch.
• Open and close the door to check that trim does not
bind and does not interfere with door latch.
Trim Strip
Trim
Strip
Figure O
STEP 10 PUSH DISHWASHER
INTO FINAL POSITION
Note: If stone
countertops
are used, see
Step 12 before
pushing the
dishwasher
Door
into the
Fits and
opening.
Swings
Back
Behind
Cabinet
Frame
Correct
Alignment
Figure P
TIP:
Check tub insulation blanket, if equipped. It
should be positioned so it is not "bunched up" or
interfering with door springs. Check by opening and
closing door.
• Push dishwasher into the cabinet. The edges of the
dishwasher door should be behind the cabinet frame
and evenly aligned with the front face of cabinet
doors.
• Carefully open and close the door to ensure the door
panel is not catching or rubbing on the cabinet frame.
7
Trim
Strip
Top View
Door Catches
on Cabinet Frame
Incorrect
Alignment