Step 17 Dishwasher Wet Test; Step 18 Replace Toekick; Step 19 Literature - GE Built-In Dishwasher Installation Instructions Manual

STEP 17 DISHWASHER WET TEST

Turn on power supply (or plug power cord into
outlet, if equipped).
Latch door.
Push "Rinse Only" button.
Push start/reset pad once.
Check to be sure that water enters the dishwasher.
If water does not enter the dishwasher, check to be
sure that water and power is turned on.
Check for leaks under the dishwasher. If leak is
found, turn power supply off, then tighten connec-
tions. Restore power after leak is corrected.
Check for leaks around the door. A leak around the
door could be caused by door rubbing or hitting
against adjacent cabinetry. Reposition the dish-
washer if necessary. See Step 12.
The dishwasher will drain and turn off about 5
minutes after it was started. Check drain lines. If
leaks are found, turn power off at the breaker,
correct as necessary. Restore power after corrections
are made. See Step 14.
Open dishwasher door and make sure most of the
water has drained. If not, check that disposer plug
has been removed and/or air gap is not plugged.
See Step 14.
Press Start/Reset pad once again and run dish-
washer through another "Rinse Only" cycle. Check
for leaks and correct if required.
Installation Instructions

STEP 18 REPLACE TOEKICK

• Place toekick against the legs of the dishwasher.
Attachment Screws
FigureBB
• Align the toekick with the bottom edge and make
sure it is against the floor.
• Insert and tighten the two toekick attachment
screws. The toekick should stay in contact with the
floor.
TIP:
Make sure toekick is against floor to minimize
noise.

STEP 19 LITERATURE

• Be sure to leave complete literature package and
installation instructions with the consumer.
11
T o e k ic k