Step 6 - Position Water Line And House Wiring; Step 7 - Insert Drain Hose Through Cabinet; Step 8 - Slide Dishwasher Partially Into Cabinet - GE GDF410SSF0SS Installation Instructions Manual

STEP 6 – POSITION WATER LINE AND
HOUSE WIRING
•Position water supply line and house wiring on the
floor of the opening to avoid interference with base
of dishwasher and components under dishwasher.
Water
Line
Figure 12
STEP 7 – INSERT DRAIN HOSE THROUGH
CABINET
•Upright the dishwasher and position in front of the
opening. Insert drain hose into cabinet wall hole.
If a power cord is used, guide the end through a
separate hole.
Insulation
Blanket
Figure 13
TIP: Position water line and house wiring on the floor
to avoid interference with base of dishwasher.
Note: If your model is equipped with a power cord and outlet
is in dishwasher cabinet area,,ensure circuit breaker is open
and plug in.
Installation Instructions
4"
6"
House
Wiring
Maximum
Drain Hose
Length 10'
Water
Line
Drain
Hose
House
Wiring
Power Cord
(If Used)
STEP 8 – SLIDE DISHWASHER PARTIALLY
INTO CABINET
DO NOT PUSH AGAINST FRONT PANEL WITH KNEES.
DAMAGE WILL OCCUR.
• Side dishwasher into the opening a few inches at a time.
Do Not Push Against
Front Door Panel With
Knee. Damage to The
Door Panel Will Occur.
•As you proceed, pull the drain hose through the
opening under the sink. Stop pushing when the dishwasher
is a few inches forward of adjacent cabinetry.
•Make sure drain hose is not kinked under the dishwasher
and there is no interference with the water
line and wiring or any other component.
7
Figure 14