Unpacking - Scotsman HD22 Product Manual

Unpacking

After removing the carton, check for the
loose-shipped parts packed in the storage bin. The
parts will include a carton with four legs. Remove
the leg carton and any other loose-shipped items.
To remove the skid, place part of the carton behind
the unit and tip the unit on its back. Remove the
bolts holding the skid to the base of the HD
dispenser and separate the skid from the unit.
Install the legs into the base of the unit, using the
holes where the skid bolts were. Turn the leg
leveler part of the legs in all the way, adjust them
later after the unit is in its final installed position.
Move the dispenser to an upright position and set it
in the location where it will be installed. Note where
drain lines and electrical connections will be made.
Top Panel
Front
Panel
Front Panel Removal
The front panel rests on the base and is located
with pins that stick up from the base. It is retained
to the side panels by strikes and latches. The top
panel keeps the front panel from moving forward.
To remove:
1. Disconnect electrical power.
2. Remove the two screws holding the top panel to
the dispenser. Lift the top panel up and off the
dispenser.
3. Pull the top edge of the front panel forward until
the two snaps disengage.
·
If the unit is a coin op model, reach behind the
front panel and disconnect the coin mechanism
harness from the front panel.
·
If the unit is a water station model, reach behind
the front panel and shut off the water supply
valve to the water faucet. Then disconnect the
water line from the shut off valve.
4. Lift the front panel up and off the base.
September 2003
Page 7
HD22 and HD30