Insert/Remove An Sdhc/Sd Memory Card - Panasonic WV-SP306 Installation Manual

Insert/remove an SDHC/SD memory card

Important:
• Before inserting an SDHC/SD memory card, turn off the power of the camera first.
• When inserting an SDHC/SD memory card, make sure the direction.
• Before removing the SDHC/SD memory card, select "Not use" for "About SD memory card" on
the [SD memory card] tab of "Basic" on the setup menu first. Turn off the power after "Not use"
selection, and then unload the SDHC/SD memory card. When the SDHC/SD memory card is
inserted or removed with the power on, data in the SDHC/SD memory card may be damaged.
(☞ Operating Instructions)
z
Open the slide cover on the side of the camera, and then insert an SDHC/SD memory card into
the SDHC/SD memory card slot.
Label face downward
A B F
S D C
A R D
L O C
x
K
If necessary, loosen the screw of the clamp for SDHC/SD memory card and tighten the screw
after rotating the clamp 90° clockwise.
Label face downward
(Recommended tightening torque: 0.19 N·m {0.14 lbf·ft})
Screw of the clamp for
SDHC/SD memory card
A B F
S D C
A R D
L O C
K
Screw of the clamp for
SDHC/SD memory card
c
Close the slide cover on the side of the camera.
v
To remove the SDHC/SD memory card, rotate the clamp for SDHC/SD memory card 90
degrees counterclockwise, push the memory card to unlock it, and remove the memory card
from the SDHC/SD memory card slot.
20
A B F
S D C
A R D
L O C
K
A B F
S D C
A R D
L O C
K
A B F
S D C
A R D
L O C
K
A B F
S D C
A R D
L O C
K
ABF
SDCARD LOCK
ABF
SDCARD LOCK
(This illustration
represents WV-SP306.)