Cirrus SR20 Flight Operations Manual page 45

Cirrus SR20 and SR22
Section 3
Visually verify all engine parameters are in acceptable ranges.
Check Oil pressure and temperature, RPM, manifold pressure,
EGT and CHT.
22. Power Lever ................................................................... 1000 RPM
23. Flight Instruments, HSI and Altimeter ................. CHECK and SET
Set all flight instruments for initial course and altitude. Verify the
HSI displays proper course and heading when checked with
magnetic compass. Ensure local altimeter has been set and is
within 75 feet of field elevation.
24. Flight Controls................................................. FREE & CORRECT
Check for full range of motion of the control yoke and control
surface deflection corresponds to yoke deflection.
25. Trim ........................................................................ SET for Takeoff
Set electric trim in the takeoff position as displayed on control yoke
arm.
26. Autopilot .................................................................. DISCONNECT
Ensure PFD heading and altitude and bugs are set and the
autopilot is disconnected. Press the Go Around button on the
throttle to engage the Flight Director in Takeoff (TO) mode. Set the
HDG and ALT bug for the assigned initial heading and altitude.
P/N 23020-002
June 2008
Flight Operations Manual
Standard Operating Procedures
3-29