Lenovo ThinkServer TD350 70DG User Manual And Hardware Maintenance Manual page 54

2. Connect the single connector on the other end of the Y cable to the AnyRAID connector 1–2 on the
system board.
To locate the connectors, refer to the related topics in "Locations" on page 16.
Connecting the SATA signal cable from the system board to the pass-through board
This topic applies only to server models that have a pass-through board installed.
To connect the SATA signal cable from the system board to the pass-through board, do the following:
1. Use one SATA signal cable. Connect one end of the SATA signal cable to the SATA connector 0–3 and
the SATA connector 4–7 on the pass-through board.
2. Connect the other end of the SATA signal cable to the SATA connector 0 and the SATA connector 1
on the system board.
To locate the connectors, refer to the related topics in "Locations" on page 16.
Connecting the easy-swap-drive module to the system board
This topic applies only to server models that come with an easy-swap-drive module.
To connect the easy-swap-drive module to the system board, do the following:
1. Connect the signal cable of the easy-swap-drive module to the SATA connector 0 and SATA connector 1
on the system board.
2. Connect the power cable of the easy-swap-drive module to the backplane power connector 1 on
the system board.
To locate the connectors on the system board, see "System board components" on page 41.
40
ThinkServer TD350 User Guide and Hardware Maintenance Manual