Setup
DMX Linking
DMX Controller or Master
DMX Linking
Diagram
DMX Mode
-10-
DMX linking connects Nexus™ 4x4 products through their DMX In and Out ports.
Nexus™ 4x4 has both 3- and 5-pin DMX ports, so either 3- or 5-pin cables, or a combination
of both, can be used. DMX linking is for DMX control and for Master/Slave control.
In DMX mode, Nexus™ 4x4 products are controlled by a DMX controller, and the DMX
address and DMX personality must be set through the control panel.
The Nexus™ 4x4 automatically senses its control source. When there is a DMX cable plugged
in, the Nexus™ 4x4 responds to DMX control. When there is a Neutrik® etherCON® cable
plugged in, it responds to an IP protocol, such as Art-Net™ or Kling-Net.
The Nexus™ 4x4 has 5 DMX personalities, each with different capabilities. The table below
lists the capabilities of each personality. For more information, see
Personality.
Personality
3-channel
5-channel
9-channel
48-channel
53-channel
RGB control
RGB control with dimmer and strobe
R, G, B, WW, CW control with dimmer and dimmer speed, strobe, color
macros, auto programs and program speed
RGB with individual pixel control
R, G, B, control with 8 WW and 8 CW controls, dimmer and dimmer speed,
strobe, color macros, auto programs and program speed
Other DMX Products
DMX Address
Capabilities
Nexus™ 4x4 User Manual Rev. 4
and
DMX