Table of Contents
Advertisement
CAUTION! Do not allow the temperature to exceed 350°F as this could
cause the laminating film to melt on the heat shoes, and will void warranty.
3. Adjust the paper guide on the feed table so that the right edge of the item will
enter the laminator at the desired position.
4. Press the motor switch to the "on" position. The film will begin moving
through the laminator.
5. When you begin laminating after the film has been sitting on the heat shoes
for a while, you should let about 6" of the film run through the machine before
you insert an item to be laminated.
6. After clear laminating film exits the pull rollers at the rear of the machine, you
may slide the first item to be laminated into the laminator with the right edge
along the paper guide.
NOTE: You may want to run a test lamination first, as any item that passes
between the heat shoes will be laminated and cannot be recovered until it
exits the rear of the laminator.
7. Additional items may be fed in sequence, keeping enough distance between
sheets for trimming.
8. After the last item has exited the pull rollers, turn the motor switch off.
9. Use a zippy cutter to cut across the film to remove the laminated items from
the unit.
10. The 5 mil option switch is a factory installed option which gives the user the
capability of laminating 5 mil laminate.
Troubleshooting
The following guide will assist you with most problems that may be encountered
when laminating.
PROBLEM:
ACTION:
PROBLEM:
Laminator is inoperative. Motor does not run and the indicator lights
are out.
Unit may be unplugged, ensure that your circuit breaker has not
tripped. Fuse may have blown. Replace the fuse (in back next to the
power cord) with 15 amp BUSS (MDA-15)
Laminator heats but motor does not turn on
14
Advertisement
Table of Contents
